Leveling tank

[kkiel02]

So I finally have the tank level!!! The problem is I did it between the 3/4 foam and the stand. Now I am wondering if this will create pressure points? To expalin it better my stand has a pedestal, then it is the stand, then the foam and finally the tank. Should I move the shims to in between the stand and the pedestal? Right now they are between the foam and the stand. Suggestions? I need this thing running asap and want to minimize stress to the tank.

[allan]

Kevin,

Level it either between the floor and pedestal or between the pedestal and stand.

Don't put it under the foam, it won't level.

[jrsatx20]

+1 on what allan said

[kkiel02]

I wish yall would have said that sooner. jk

I had it like that at first but this took away the gap between the stand and pedestal so I liked the look better. Well off to take out the shims..... again. lol

[jrsatx20]

put a carpet runner in front of the tank.

[kkiel02]

I put the shims between the pedestal and the stand so I wouldnt leave imprints on the floor. Its not that bad I will see how it looks with the fuge light in there. Plumbing tomorrow then filling this weekend!

[BIGBIRD123]

All you have to do is use black caulking to fill in the gap after the shims...

[Gseclipse02]

was there a reason you chose not to use a DSA stand?

[CoryDude]

was there a reason you chose not to use a DSA stand?

There's probably a $1000 reasons why he didn't use their stand. Besides, the tank would still need to be leveled no matter who's stand he used.

[Neptune@gabesfish]

There's probably a $1000 reasons why he didn't use their stand. Besides, the tank would still need to be leveled no matter who's stand he used.

I think if it was on DSA stand it would not need any leveling unless the area he put it is hat bad..