BC 8g water flow

[StevenSeas]

i used PVC piping with a piece of plexi glass attached on the top as a stand of sorts

[TEXASFIST210]

need more details is there any videos on doing this or instructions?

[StevenSeas]

No i dont know of any detailed instructions but ill try.
First measure the length of the output tubing. Then decide how much you want to raise the pump, then cut that much off the tubing. If you want to raise it 5 inches then cut 5 inches off the output tube. Then cut about a blades width shy of 5 inches, or whatever amount you decided to raise the pump. Then measure the footprint of the pump and cut a piece of plexi (any thickness). Then use somethin like weldon 16 to attach the plexi to the PVC. Then put the stand in the third chamber and then attach the pump to the tubing. If its too tight a fit use a lighter to make it easier to fit around the output on the pump, then put the pump on the stand and you should be good to go

[StevenSeas]

Hope that help let me know, the only pic i can get you is of the stand itself not anything else, as the tank is in SA

[TEXASFIST210]

yeah just send the pick

[StevenSeas]

pics are uploading to photobucket now ... dont expect anything amazing

[StevenSeas]

here ya are