Events

**Bill S** · Mon, 21st Apr 2008, 11:56 AM

Or the resin canister was mounted horizontally, allowing water to tunnel thru the resin.

**RayAllen** · Mon, 21st Apr 2008, 12:51 PM

And then........ To many variations of things that can be wrong.

**subsailor** · Mon, 21st Apr 2008, 01:21 PM

Maybe you didn't wash your hand good before replacing and you got stuff from your hands on it

**BIGBIRD123** · Mon, 21st Apr 2008, 01:49 PM

didn't turn the flush valve off...

**bigmoe21** · Mon, 21st Apr 2008, 04:04 PM

what is your unit is not a buckeye unit?

**BuckeyeHydro** · Mon, 21st Apr 2008, 05:37 PM

Originally Posted by ScorpiNO

The storage container for the new water is not clean, so the TDS is elevated due to dirt or some kind of buildup that occured. You said all of this was in storage right?

Nope - the tds was being tested right from the DI output tube.

**BuckeyeHydro** · Mon, 21st Apr 2008, 05:39 PM

Originally Posted by Texreefer

maybe the DI resin chamber was packe too tightly with too much resin, causing the water to flow through too fast with not enough contact time

I've never run across a case of resin being packed to tightly.

**BuckeyeHydro** · Mon, 21st Apr 2008, 05:40 PM

Originally Posted by bstreep

Or the resin canister was mounted horizontally, allowing water to tunnel thru the resin.

You're getting warm!

**BuckeyeHydro** · Mon, 21st Apr 2008, 05:41 PM

Originally Posted by subsailor

Maybe you didn't wash your hand good before replacing and you got stuff from your hands on it

The resin change was done with gloves - its not a contamination issue.

**BuckeyeHydro** · Mon, 21st Apr 2008, 05:42 PM

Originally Posted by BIGBIRD123

didn't turn the flush valve off...

good guess but flush valve is closed and 4:1 waste to permeate ratio was measured.

UPCOMING: Events

Thread: RODI Mystery de jour

Thread Tools

Display

Tags for this Thread

Posting Permissions