Quote Originally Posted by tg1119
matt: well at the time it wasn't making any foam being pushed into the cup. It will produce skimmate for a while but then it will just stop.

JimD: Is the easiest way just to undo the screw and go in from the top?

Where should this screw be set? I mean how many times should I turn the screw driver when putting the screw back in. I counted 6 rotations when I took it out but I do not know if the guy every adjusted it before me. What is a good refrence point when I put the screw back in?
Just unscrew it all the way out, then clean the injector with a brush like I said, then, carefuly align it back on the hole, be careful not to crossthread it and tighten it so its just snug probably about a quarter inch above the gray tube. Whatever you do, dont screw it all the way in so it falls into the little chamber below, if you do, youre screwed. Remoras can be a little finniky at times, adjust the cup so its about an eigth inch below the water surface. Ive never gotten any sludge out of mine, mostly green tea, and typicly, they can be rather loud.