Guys I hooked up my JBJ ATO today along with my Toms Aqua lifter.

My problem ..

The Sensor and pump lights on the JBJ come on and it starts pumping water into the sump as it should and after a short period of time it stops pumping the water although it has not reached the float switches. So the lights on the sensor lights on the JBJ remain on because it has not filled to the float switch. If I flip the power switch on and off the pump with then start pumping again. From my understanding there is a timing switch or something in the JBJ that times out. Is this the problem.

Right now the Reservoir sits to the left of the sump and the Aqua lifter is a few inches above it and the sump. From what i have scene this is the optimal setup.


I may take the Aqualifter back and replace it with a small MJ or something if I can not figure it out...