240g Full Blown DIY Build (Full SPS) (SUMP DONE!)

[OneReef]

40x19x15

[BBQHILLBILLY]

wow thats a good looking sump, very nice footprint

[koa25]

That is a stellar sump. Very well made.

Sent from my SCH-I545 using Tapatalk

[OneReef]

Thanks guys!

Got the stand welded up. Grinding down the welds then finishing it off.

[moneytank]

Can I suggest adding feet to your stand. That way the entire metal stand is not sitting on the ground. Sure would make a difference when those "oops" moments happen and water goes to the floor. You will not be able to get all the water out from underneath the metal touching the floor.

I welded metal feet on the bottom of mine, raising the base up about 4"s. So I have only six feet resting on the ground. I painted the stand with por15 and the had it under coated. The only part that has any rust after 5 years is the parts that actually touch the floor.

[OneReef]

I had thought about it but it's too late. All top and bottom corners are mitered so adding feet would be a little hard. I dont know if I'd trust adding tabs on the inner corners to mount feet. I'll just had a wet tray lined with water resistant vinyl to help contain any water.