Web Member2
replacement chiller fittings
i have this chiller, it's an aquachill 1/4 hp the only problem is that i have no way to connect it, and in a garage a chiller is essential. does anyone have an old broken chiller i could plunder the elbows off of, or perchance have a spare set. i actually already have one of them, and was able to find out that current elbows will fit just fine, but the jbj pieces will not. i tried using pvc to make my own and the thread pitch is off by a bit. if anyone has one or two let me know
mike
Web Member
What size elbow's? I think I have a couple of 1" mpt 90's w/barbed fittings. I never needed them so they're unused. No charge. Just let me know if you need them.
Oh, these elbows are for a current/prime chiller.
Last edited by CoryDude; Wed, 26th May 2010 at 10:26 AM.
I refuse to join any club that would have me as a member.
Groucho Marx
Web Member
Just found the entire bag of fittings that came with the current chiller. You're welcome to the entire thing. All are 1" 90 degree mpt fittings w/barbed fittings for flex tubing. Two of the fittings are for 1" tubing and there are another two for 3/4" tubing. You're welcome to take them at no charge. I'm not using them anyways.
I refuse to join any club that would have me as a member.
Groucho Marx
Web Member2
awesome prolly juxt what i needed. when and where can i get those offa you?
Reply With Quote
