Question about acrylic

[hobogato]

tough crowd! i thought everyone forgot about frankensump!

But my sumps looks better than the one he built with wood.


David

just so you dont think i am a hack, this is what you can do with some patience and good router bits



if you are using a table saw, get a good finishing blade - it will give you a nice clean cut. go slow so it doesnt get hot while you are cutting it. over size your outside pieces a little so after you glue it you can trim them to the perfect size with a laminating bit on a router. then round off the sharp edges with a 1/8" rounding bit on the router so you dont cut your fingers on the edges like david and bill do.

[jtrux]

Thanks for all the responses

[erikharrison]

lol Ace.

[tomanero]

http://www.duboisi.com/diy/BNdiytank/bndiytank.htm

I found this a helpful link for acrylic building.

[jtrux]

Thank you.