Reefkeeper Lite System - iTemp and PH Probes.

[Ms. Mermaid]

Where is everyone placing the iTemp and PH Probes at?
Inside the overflow boxes or the sump?
If in the sump which chamber are they in?
Are they fully submerge able or partially ?

[alton]

I feel like I have seen these questions before? Several of us from MAAST are on RC also. I only use a iTemp, not PH, 3/4's covered in water in the center section of my sump in my 65, overflow on my 300. I believe the sensor to be on the bottom of the probe? The best way is to build an acrylic holder for the sensor to hold it in place. Mine just floats around but has worked for years.

[Ms. Mermaid]

I feel like I have seen these questions before? Several of us from MAAST are on RC also. I only use a iTemp, not PH, 3/4's covered in water in the center section of my sump in my 65, overflow on my 300. I believe the sensor to be on the bottom of the probe? The best way is to build an acrylic holder for the sensor to hold it in place. Mine just floats around but has worked for years.

You probably did. I have it posted on RC as well.