Dry PH Probe

[Dominican]

My Milwaukee PH probe arrived dry. I thought it had juice inside the little rubber cap that came over the end of it, but when I took it off it was dry. :( The instructions say to use a "M10000B" solution to "reactivate" the probe, but no such solution is in sight. Anyone know where I can get this stuff, or if there's a common alternative? Thanks...

[aquasport24]

they also called calibrate fluid (PH7,and PH 4 fluid) for MILWAKEE probe. Most LFS do carry them..

[Dominican]

I was connecting the controller to calibrate with the PH7 and PH4, which I have. Actually, the PH4 didn't come in the box, so I had to get it from Aquatek. You're saying I can just use one of those???

[aquasport24]

yes i used just the ph7 to calibrated my probe. ph 7 is for the high side and the ph4 is for the low side.

[JimD]

Since the normal Ph range should be between 7.8 and 8.5, you should be using calibration fluid rated at 7 and 10.

[aquasport24]

that's all depend ,if you're using it for effleunt drip from calcium reactor or just reading the main tank water.