Need acrylic work done

[MIOR6485]

I just got this custom skimmer and I noticed that the acrylic cylinder attached to the lid overlaps the riser tube too much. Performance wise, it is not an issue but it does reduce the capacity of an allready short collection cup. As the waste increases it begins to cover this cylinder preventing the air from escaping thus resulting in a burping noise. What I like is for someone to shorten the cyclinder so that it is flush with the top of the riser tube.

If anyone can do this for me please reply to the post.

thanks again

louis

[emilbus]

try Hobogato formaly known as ACE

[hobogato]

yeah, bring it by and ill cut it down for ya. 8466784

[MIOR6485]

Thanks so much.

I will call you over the weekend.

Louis 667-8902