Problem? with a Pro Heat II titanium heater tube?

[Bill S]

Take a look it this photo. This is the heater I got from mikeyboy. It has some pretty deep pits on it - should I be concerned? Is there a way to repair it? Like some JB Weld?

[GaryP]

Silicone might be a better way to fill the pits. It'll bond to glass and is heat resistant.

[Bill S]

DANG. Good thought, Gary.

[GaryP]

I have one every once in a while. Is there a blue moon this month?

[ratboy]

I'd worry more about the controller than the tube. I had a few won II's go bad. One switched always on , 2 switched to always off. This is both the dial and digital controls...