pilot_bell777
Sat, 3rd Dec 2005, 01:36 AM
The tank is up.....all trim is on, all plumbing is done..
Ed..I've redone the plumbing twice since you were over by the way! LOL
All is working properly.........keep your fingers crossed!
MH is hung, Antinic is in, PCs are hung over the fuge, New Panworld pump from Polkster is rocking (man that thing is WAYYYYY quiter than my IWAKI with more power too!), skimmer is skimming, sand is settling, SCWD is switching, all timers/ballast etc, etc are installed, ran, and programmed, line from RO/DI is installed on the float valve, dosing pump is cleaned and pumping (not dosing yet, but it needed to be cleaned and now it is and working corretly), heater is heating, temp is reading.....and my bad *** Piranha Mag Scrapper is in the tank! YEA
YEA
YEA
YEA!!!!!!
The 55 gallon barrel is finally out of my living room! LOL :lol
Pics coming soon!
Ed..I've redone the plumbing twice since you were over by the way! LOL
All is working properly.........keep your fingers crossed!
MH is hung, Antinic is in, PCs are hung over the fuge, New Panworld pump from Polkster is rocking (man that thing is WAYYYYY quiter than my IWAKI with more power too!), skimmer is skimming, sand is settling, SCWD is switching, all timers/ballast etc, etc are installed, ran, and programmed, line from RO/DI is installed on the float valve, dosing pump is cleaned and pumping (not dosing yet, but it needed to be cleaned and now it is and working corretly), heater is heating, temp is reading.....and my bad *** Piranha Mag Scrapper is in the tank! YEA
YEA
YEA
YEA!!!!!!
The 55 gallon barrel is finally out of my living room! LOL :lol
Pics coming soon!