BRS DIY Screen Top?

[sergiotami]

I ordered one, but no instructions... Anyone ever assembled one? If so how much do cut off ends to compensate for corner insert?

[SABOB]

Louis at Elegant Reef did mine, bet you could call him and he'd know


Sent from my iPhone using Tapatalk

[alton]

I left a inch and went back and trimmed it after with a razor knife

[sergiotami]

I had a two gobies jump in less than a week so I ordered the kit. Just want to make sure I cut the frame lengths right... :)

[SABOB]

Better to error and cut too long,can always trim more off.....Ask me how I know,Lol


Sent from my iPhone using Tapatalk

[slm222]

For mine I put an end on and put it on top of the tank where I wanted it set the other end on top and marked with a permanent marker and then took outside and cut

[slm222]

The thing I'm trying to figure out is how to get my jebao cords out of the tank and get a good seal to keep the fishies in

[Awais98]

The thing I'm trying to figure out is how to get my jebao cords out of the tank and get a good seal to keep the fishies in

If u can cut the corner outer edge carefully you'd have a place for the cords to pass


Sent from my iPhone using Tapatalk

[zerreissen]

The thing I'm trying to figure out is how to get my jebao cords out of the tank and get a good seal to keep the fishies in

I left a gap at the back of the tank large enough for the cords to fit through. Haven't had any jumpers since I've installed the screen.

[MrSkumFrog]

I realize you probably have already finished your top; but in case you haven't...
i made it so it sits entirely on the top edge. I used stick-on rubber feet to create a small gap for chord to pass.
I made a YouTube video under mrskumfrog

[sergiotami]

I did, but will check out video.... Thanks... :)