Glass cutting

[allan]

Folks,

I went to HD to find a glass cutting drill bit and the largest they had was 1/4". I was thinking half to a full inch would be needed. Where do I find this bit?

Looking to get it today.

[txmike]

look at HD or lowes by the tile stuff they may have one

[allan]

I can try loses. HD had the tile/glass bit no larger than a quarter inch.

[Neptune@gabesfish]

Dont know if this helps any but if you are drilling for a bulkhead the breakdown is

1/2 bulkhead-1 1/8 Diam hole
3/4 bulkhead-1 7/16 to 1 1/2 diam. hole
1 in bulkhead-1 3/4 diam hole

from what I have seen they normally do not sell these at HD or LOWES .. Look on gl*******s.com they sell them there for a real good price..

[hobogato]

i have a 1 1/8 " one you can borrow if you want to swing by.

[allan]

Gabe, thanks dude, didn't have those numbers handy.

Ace ,

I can swing by in about half an hour if that's cool with you?

[hobogato]

works. i have other sizes too, in case that one wont work. i think the only one i dont have is the one for a 3/4" bulkhead.

[allan]

'k, on my way.