Log in

View Full Version : korolia



p00num3lli
Tue, 13th May 2008, 05:25 PM
do any of yall have those korolia(not sure if its spelled right) power heads? well i bought a #3 and if i unplug it and then plug it back in, everytime the cover pops off and the propeller shoots out, this happened to yall? it really gets on my nerves. cuz then i have to wash my hands good and then reach in the tank, get it out, then pout it back to gether, then put it back in

drgnbttrfly
Tue, 13th May 2008, 05:39 PM
make sure the needle is in the hole ALL the way in the front (where you can pop the front piece off) and pop the top back on...then screw the other piece that popped off back on...you shouldn't have any more trouble

mine was off just a smidge and it happened a couple times till I figured it out...I took it out and took it apart and sure enough it wasn't alligned right

good luck!

p00num3lli
Tue, 13th May 2008, 05:48 PM
make sure the needle is in the hole ALL the way in the front (where you can pop the front piece off) and pop the top back on...then screw the other piece that popped off back on...you shouldn't have any more trouble

mine was off just a smidge and it happened a couple times till I figured it out...I took it out and took it apart and sure enough it wasn't alligned right

good luck!

hey, where does that little round piece go at? its about an inch and a half long all the way around. the first time it poped off wen i tunre d it on and off it came off. and i cant figure out were it was at, aaand i lost the directions(slaps myself)

aquasport24
Tue, 13th May 2008, 05:49 PM
Becareful when you take out apart, there is a small O-ring at the end of the impeller rod. It would run very noisy if you loose the 0-ring. good luck

p00num3lli
Tue, 13th May 2008, 05:55 PM
Becareful when you take out apart, there is a small O-ring at the end of the impeller rod. It would run very noisy if you loose the 0-ring. good luck

trust me! lol i nearly lost it! when it came of i barly noticed it came off, good thing i did.. took me nealr five minuits to figure out were it went

aquasport24
Tue, 13th May 2008, 06:10 PM
the small round piece would goes inside small opening of the housing(make sure all the slots are line up)before you pop it in.

drgnbttrfly
Tue, 13th May 2008, 06:11 PM
i believe it goes before the fan blade