Log in

View Full Version : Building of the 58 Gallon Tank



princer7
Sat, 5th Jan 2008, 09:27 PM
This 58 gallon tank is going to be the upgrade to my current reef tank - a 24 gallon Aquapod w/ 150w HQI. Right now the -pod is chock full of SPS, zooanthids, and shrooms along with my pair of picasso clownfish with their BTA. I am excited about this new project and hope to get it right.... Suggestions always welcome and much appreciated. :)

Current Equipment List:

Tank:

58 Gallon Oceanic Tank (36x18x21)
Oceanic Black Stand
Black Oak Canopy (open on top and back)Lights:

(2) LumenBright Mini reflectors
(2) 250watt 12,000K Reflux SE bulbs
(2) Coralvue electronic Ballasts
Icecap 430 ballast w/ (2) 39watt T5 UVL Super Actinic 420nm - going up for sale soon!Equipment:

Aquacontroller Jr. w/ pH and Temp. probes
Octopus Xtreme Reef Protein Skimmer INT-PS-120 (Unfortunately not the one with the Sicce pump)
Sump / Wet-Dry - no bioballs
1/15HP Prime Chiller
CPR Aquatics HOB Refugium - LargeI tested just a single LumenBright and got too much light drop-off on the sides so I am going with 2 of these reflectors. Hope it is not going to be too much light or heat. There is not enough room in the canopy for running actinics as the reflector is too big - 16" in diameter on an tank with a surface area of 36"x18".

I am contemplating the tank dosing - continue with just B-Ionic and dose with a pair of dosing pumps or go with a calcuim reactor.
I really want a stable tank and good color and growth. The less day to day maintenance the better - I've got a full-time job, 2 boys, husband, dog, cat, housework, etc. :what_smile:

tony
Sat, 5th Jan 2008, 09:37 PM
im going to watch this closely, it is a very similar setup to my 45g im working on right now

good luck with it

princer7
Sun, 6th Jan 2008, 10:08 PM
It was an expensive day! I purchased many of the missing pieces to get this project off the ground. I'll be waiting (un)patiently for the FedEx truck this week. Once the remaining pieces are in, plumbing will be the biggest challenge. (any pros out there????) I have seen some really clean setups - wish my tanks were so tidy :what_smile:. I am hoping to assemble by this coming weekend. :bigsmile: Hope it all fits under the tank:confused:

Here is what was ordered today:


Electrode Holder
Ground Isolated Serial Connector - The Aquacontroller pH is always wrong when connected to the PC.
MRC Nano Dual chamber Calcium Reactor
5 lb. Aluminum CO2 Cylinder
Milwaukee CO2 Regulator, Solenoid, Bubble Counter
A.R.M. Calcium Reactor Media
ZeoMag - Magnesium Granulate
(2) Phos Ban Media Reactors - 1 for carbon the other for PhosBan
PhosBan
Super Activated Carbon
Aqua Lifter Vacuum Pump